Editorial desk
ResinPrintGuide Editorial
The editorial desk that publishes ResinPrintGuide. It is a byline for the site's editorial process, not a person, and this page carries no author biography because there is no individual author to describe.
How this desk works
- Articles are researched from primary sources: vendor and project documentation, published standards and specifications, release notes, advisories, and measurements published by the people who took them.
- Drafts are produced with AI assistance and then edited against those same sources before publication.
- Nothing published here claims hands-on lab testing, benchmarking, or first-hand measurement. Where a figure comes from a datasheet or someone else's test, the article names the source.
- Corrections go to hello@resinprintguide.com and are made on the affected page. Funding is set out on the disclosure page.
Posts (11)
- materials
Water Washable Resin vs Normal Resin: Which to Buy
Water washable resin vs normal resin compared on wash time, strength, moisture and waste, with a clear pick for minis, props and functional parts.
- calibration
How to Add Supports to Resin Prints: Placement and Settings
Where resin supports go and why: tilt angle, islands, auto versus manual placement, tip size and depth, with Chitubox, Lychee and PrusaSlicer values.
- post-processing
Water Washable Resin vs Standard Resin: Key Differences
Compare water washable and standard resin by chemistry, wash workflow, strength, moisture sensitivity, and disposal requirements before choosing a type.
- buying-guide
Best Small Resin 3D Printer for Miniatures: 5 Picks
Footprint first: compare five small resin 3D printer picks for miniatures by published dimensions, desk fit, XY pixel size, build volume and features.
- post-processing
How to Dispose of 3D Printer Resin Safely
Liquid resin and contaminated solids must be fully cured, while resin-loaded IPA goes to hazardous waste and nothing enters a drain.
- post-processing
How to Wash and Cure Resin Prints: Solvents and Timing
A step-by-step guide to washing, rinsing, drying, and curing resin prints, with solvent choices, timing ranges, quality checks, and safe disposal.
- troubleshooting
Resin Print Layer Separation: Causes and Fixes
Diagnose resin print layer separation during a print: check normal exposure, resin temperature, cross-section changes, supports, pauses and hardware.
- buying-guide
Resin 3D Printing Starter Kit: What You Actually Need
What a resin 3D printing setup needs beyond the printer: gloves, IPA, a wash and cure workflow, ventilation, spare film, and the consumables nobody lists.
- troubleshooting
Resin Print Not Sticking to Build Plate: 7 Fixes
Why resin prints stick to the release film instead of the build plate, how to tell the failure modes apart, and the seven fixes that resolve most of them.
- buying-guide
Resin vs FDM 3D Printing: Which One to Buy
Resin vs FDM compared on detail, strength, speed, running cost, and the post-processing and ventilation burden that decides which one fits your room.
- calibration
How to Calibrate Resin Exposure Time on an MSLA Printer
Resin exposure calibration for MSLA printers: how to run a stepped test, read the failure signs, and adjust for layer height, resin, and temperature.