Supports
-
How to Add Supports to Resin Prints: Placement and Settings
Where resin supports go and why: tilt angle, islands, auto versus manual placement, tip size and depth, with Chitubox, Lychee and PrusaSlicer values.
-
Resin Print Layer Separation: Causes and Fixes
Diagnose resin print layer separation during a print: check normal exposure, resin temperature, cross-section changes, supports, pauses and hardware.
-
Resin Print Not Sticking to Build Plate: 7 Fixes
Why resin prints stick to the release film instead of the build plate, how to tell the failure modes apart, and the seven fixes that resolve most of them.